Sunday, June 11, 2017
Thursday, June 8, 2017
Thursday, June 1, 2017
This unidentified attack is an attack to be remembered.
| Subject: | This unidentified attack is an attack to be remembered. |
| Date: |
6/1/2017 9:07:40 A.M. Mountain Daylight Time
|
In addition to tyranny, the following from our National Science
Foundation is infuriating:
|
Tuesday, May 16, 2017
Insiders and The Roots of Fukushima
Of course, there are countless roots, and it may be argued that some do not apply. The number of applicable roots grows substantially if the ways of doing business are included. Following is stuff from decades ago that documents NRC-EPRI relationships that are not otherwise disclosed.
This entry jumps ahead of a lot of documentation that I have and that I guess I'll have to place in book if I ever get around to writing that. On November 7, 1984, EPRI (Rossin and Breen) told me my position was being eliminated, but that I'd have a few months to look for work elsewhere. So, I looked elsewhere with no immediate success. I talked to Jim Keppler of the NRC and showed him my memorandum, UHI Ultra High Risk, October 3, 1984, as part of several illustrations of my experience and capabilities. Keppler asked if he could send this elsewhere in NRC and I agreed, however, I blanked out the source of the document as well as my name.
So, the following two pages are an interesting document that reveals very secret relationships between EPRI and the NRC that I was never aware of. It also reveals turmoil. I do not recall how I gained access to the following document; it most certainly was not sent to me. I am inclined to doubt that Rossin was aware of it, but I do not know that. I suspect that Layman and Lang were not aware that my position had been eliminated.
Click on a page to enlarge and the back arrow to return.
This entry jumps ahead of a lot of documentation that I have and that I guess I'll have to place in book if I ever get around to writing that. On November 7, 1984, EPRI (Rossin and Breen) told me my position was being eliminated, but that I'd have a few months to look for work elsewhere. So, I looked elsewhere with no immediate success. I talked to Jim Keppler of the NRC and showed him my memorandum, UHI Ultra High Risk, October 3, 1984, as part of several illustrations of my experience and capabilities. Keppler asked if he could send this elsewhere in NRC and I agreed, however, I blanked out the source of the document as well as my name.
So, the following two pages are an interesting document that reveals very secret relationships between EPRI and the NRC that I was never aware of. It also reveals turmoil. I do not recall how I gained access to the following document; it most certainly was not sent to me. I am inclined to doubt that Rossin was aware of it, but I do not know that. I suspect that Layman and Lang were not aware that my position had been eliminated.
Click on a page to enlarge and the back arrow to return.
I'm certainly pleased that EPRI (Layman and Lang) documented the above. This is a clear report of a basically secret set of arrangements between EPRI and the NRC and I suspect that those have continued in various forms over the years and are really intense in today's post-Fukushima world.
The second page is "interesting" as it describes the "running around" in generating a response to Keppler. The very last paragraph is also revealing as EPRI apologizes to the NRC for my contact with Keppler.
Friday, February 10, 2017
Isotope Separation, Boron
This summary paragraph, Proximity Separation and
Deposition in the Microscale, outlines Leyse’s transformative approach to isotope
separation. Leyse’s discoveries are now
applied in the new field named Microscale Process Intensification. With one set of apparatus, and with one platinum microscale heat
transfer element, Leyse’s research covered the pressure range from 2 to 45 MPa,
the heat flux range from very low to 4000 W/cm2 and the temperature
range of the heat transfer element from 25 oC to 870 oC
while bulk water temperature was maintained in the range of 20 oC. At the very high heat flux
there is intense turbulence in the vicinity of the microscale heat transfer
element. The local fluid temperatures range from the saturation temperature to
intermediate temperatures. The complex
thermal hydraulics defies analysis with current tools. A dilute solution of boric acid will
decompose within the high temperature field to yield particles of insoluble
boric oxide. A fraction of the
particles of boron oxide thus produced will deposit on the hot element. If
there is difference in the deposition rates, the mix of 10B and 11B on
the element will be different than nature’s blend..
Thursday, February 9, 2017
Nukiyama in microscale; text, but no slides, too bad.
This transformative presentation takes 10 minutes -- or
less. It was ahead of its time over 20
years ago and it still is.
This paper is Nukiyama in microscale over the pressure
range from 200 to 6000 PSI. Nukiyama
used a platinum wire simultaneously as a heat transfer element and a resistance
thermometer.
Here is my Nukiyama element: diameter 7.5 microns, length
1.15 millimeters.
It is installed in the lower end of an upright tube that is filled with pressurized water, pure and degasified at about 20 Centigrade. The steel tube is used for these pool boiling runs at higher pressures.
The benchtop apparatus has the pool boiling tube, the
pressurizing pump, the junction box and programmed power supply, a PC with
Excel for data logging, and in the back, a Rosemount recording pressure
transducer.
A run takes about 11 seconds and data is recorded every
tenth of a second. Heat flux is smoothly
increased and then decreased. In this
run at 1000 PSI with the water at about 20 Centigrade, the peak was over 4000
Watts per square centimeter. The average
power is about one half watt, so the energy is about 6 watt-seconds, or less
than two calories for the 11 second run.
So, the temperature of a local gram of water increases by less than two
Centigrade.
Following is the reduced data for the 1000 PSI run. It doesn’t get any better than this although
it gets more exciting. The transition to
phase change, I call it the Nukiyama point, is at about 2100 watts per square
centimeter. This transition is extremely
sharp, there is no sluggishness. That is
also the case at the turnaround at 4100.
I want to increase the recording rate to every millisecond in further
runs. Note that the return is on the
same path as the rise. Clearly, the
local temperature stays very close to 20 Centigrade, otherwise the return would
not overlay.
Here are several runs, three subcritical, one
transcritical, and four supercritical. You have seen the dissection of the 1000
psi run; the 200 and 2500 of this plot are similar. The dotted line is the transcritical run at
3000. The four supercritical runs range
from 3600 to 6000.
Here are the 3600 and 6000 runs. The 6000 has a narrower spread between the
power up and the power down.
The 3,000 transcritical run is superimposed on the runs
you have just seen. I want to expand
this territory with runs having millisecond data collection.
The supercritical runs are all well-behaved in this
plot. Even the transcritical falls in
its proper place.
The point of the following plot of the subcritical runs is that at
200 psi the Nukiyama point is 65 Centigrade beyond saturation while at 2500 and
above, that delta T is very narrow.
With the permission of Professor Victor Yagov of Moscow, following
is his recent analysis. At 200 psi he reports substantial Delta T’s, at 3000,
the Delta T’s are vanishing. Multiply Yagov’s
values by 100 to get to my units.
This is the transcritical run. Again, I want millisecond data recording next
time in the search for the aspects of the jump.
Note that saturation temperature is very close to critical.
Here is limited data.
With a somewhat larger microscale element the heat fluxes at the
Nukiyama points are reduced, however the temperature of the points is
unchanged. The transcritical
characteristic is the same even though the pressure is 100 psi less; the
saturation temperature is still very near critical.
I think this is sensational. The procedure is to pressurize the apparatus
to about 6000 psi, apply a substantial heat flux in one step, and maintain that
heat flux as pressure is smoothly reduced over about 20 seconds, turn off power
at about 200 psi. Note the gradual
increase in temperature as pressure is reduced, then the upward jump of over
200 Centigrade at around 3700 psi, followed by a smooth increase of another 100
Centigrade to the critical pressure, then a smooth decrease of nearly 200
Centigrade, then a downward jump of about 150 centigrade to the critical
temperature. At that point the subcritical boiling begins and continues until
the power is turned off. At the lowest heat flux there is a smooth continuous
plot over the entire pressure range with no intervening steps. The four plots
at increasing heat fluxes are neatly nested.
Here are the data points.
I captured one point during the upward jump in two runs. Of course, runs
are needed with millisecond recording, etc.
Here are the plots of subcritical phase change only. The plots are very close; however the heat
fluxes are distinct. As was measured in
the constant pressure runs at subcritical pressures and also calculated by
Professor Yagov, the delta T from phase change to saturation increases as the
pressure is reduced.
This shows the impact of nitrogen saturation at 1000
psi. I never reduced these plots to heat
flux and temperature; I did not need to in order to get the patent. Nitrogen
reduces the heat transfer coefficient during natural circulation; however phase
change heat transfer begins at a somewhat lower temperature and heat flux. I filed this patent during 1995 and it issued
during 1997, the year that Berkeley started its microscale journal.
Thursday, November 24, 2016
INL CAB October 27, 2016
The Idaho National Laboratory (INL) Site Environmental Management (EM) Citizens Advisory Board (CAB) held its quarterly meeting on Wednesday, February 17, 2016, at the Hilton Garden Inn in Idaho Falls, Idaho. An audio recording of the meeting was created and may be reviewed by calling CAB Support Staff at 208-557-7886.
Public Comment
Robert Leyse, Sun Valley, commented that in the June 2016 meeting minutes McBride asked if DOE regrets having waited to begin pilot testing at Hazen Laboratories until the Inspector General suggested it. Leyse noted that he addressed the CAB a year ago, and provided a series of links that are available in the October 2015 meeting minutes.
Those links show the following: In a report dated September 11, 2006, a review commissioned by DOE-ID and chaired by David S. Cosin, PhD, reported several findings including Finding One of their report: “Documentation, data reduction and analysis are incomplete for the pilot scale testing carried out to date at Hazen Laboratories. Consequently, thorough analysis of these data has not been completed; insufficient attention to these aspects of pilot testing has been the cause of other DOE program failures.” Leyse commented that IWTU can be added to those failures. Ten years ago, Hazen reporting was deficient. Leyse asked why DOE is resuming work at Hazen today. The third link reveals that on January 24, 2007, the Defense Nuclear Facility Safety Board (DNFSB) had no objections to proceeding with construction of IWTU. The first link shows that during 2014, DNFSB did not authorize operation of IWTU with radioactive feed, “A lack of assurance that the facility can safely proceed with nuclear operations…” Leyse commented that it is surprising that DNFSB did not approve nuclear operations as they should never have approved construction of the facility to begin with.
Following is the Leyse list of references that Leyse provided at the CAB meeting in Sun valley, Idaho, on October 29, 015
The Idaho National Laboratory (INL) Site Environmental Management (EM) Citizens Advisory Board (CAB) held its quarterly meeting on Thursday, October 29, 2015, at the Sun Valley Inn in Sun Valley, Idaho. An audio recording of the meeting was created and may be reviewed by calling CAB Support Staff at 208-557-0843
Letter provided by Mr. Robert Leyse during the Public Comment Period:
LEYSE STATEMENT DISCLOSING DNFSB EVALUATIONS OF IWTU
Hello, I am Robert Leyse of Sun Valley, Idaho and I want the public to know that I have found the following via GOOGLE. I am including the links so that others may check my findings.
Link 1:
http://www.dnfsb.gov/sites/default/files/Board%20Activities/Reports/Staff%20Issue%20Reports/I daho%20National%20Laboratory/2014/sir_2014523_24466_37.pdf
DNFSB investigated the status of the IWTU and reported its findings to DOE May 23, 2014. It reported “…a lack of assurance that the facility can safely proceed with nuclear operations.” “Therefore, pursuant to 42 U.S.C. § 2286b(d), the Board requests a report and briefing within 30 days, on DOE's evaluation of the need for additional independent assessment at the completion of IWTU startup testing and prior to the introduction of radioactive waste feed.”
Link 2:
http://www.dnfsb.gov/sites/default/files/Board%20Activities/Letters/2014/ltr_2014620_24626.pdf
This is the 30 day reply letter from DOE to DNFSB and it reports agreement that “…IWTU will benefit from an additional independent assessment…”
Link 3:
http://thortt.azurewebsites.net/docs/DNFSB%20Letter.pdf
This documents a DNSFB review, January 24, 2007. “The Board has no significant safety issues with the project at this time (Critical Decision 2/3B). The final design, however, is progressing and there remain a number of items the Board believes must be addressed before the approval of final design and construction of the project.” … “The Board commends DOE for considering a potential future mission in this facility. Further, DOE convened an expert panel early in preliminary design to confirm that the design of the facility could accommodate this mission. The Board is encouraged by the project’s commitment to address this panel’s recommendations.”
Link 4:
http://www.cresp.org/crespII/CRESPII_Report/E_attachment/INLreview_complete_9_11_06.pdf
This is the report of the expert panel that is praised in 4. The report lists 17 findings and associated recommendations. Here is the first of 17: “Finding 1. Documentation, data reduction and analysis are incomplete for the pilot-scale studies carried out to date at Hazen Laboratories. … Insufficient attention to these aspects of pilot-testing has been a cause of other DOE program failures.” ”Recommendation 1. Thorough documentation, data reduction and analysis of the results from pilot scale testing carried out to date should be completed as soon as possible and to the extent practical before initiating the planned next stage of pilot-scale testing.” LEYSE
CLOSING STATEMENT Others may download the above links and also search for other links regarding the IWTU. You may easilyaccess the above links via GOOGLE at leyse nuclear power blog dnfsb.
Subscribe to:
Posts (Atom)




